Water 4 Gas Fuel Heater
Monday, June 9th, 2008
This weekend I assembled the water 4 gas fuel heater. It didn’t take much effort. I went to the local hardware store and got the brass pieces and fittings needed and put the device together with some pipe sealant.
This is considered phase 2 of the water 4 gas system. A quick review of the theory behind this device. It is used to heat the fuel before it enters the combustion chamber. Basically, the plan is to buy the fuel cold and in a condensed state and then heat it, forcing it to expand before it enters the combustion chamber.
I have no idea how this will work in increasing my fuel economy. I have also found very little information on the Internet supporting or denying the validity of this claim that heating the fuel will increase fuel economy.
Back when I was in automotive training in the early 80s. Our teacher told us a story I will share with you but cannot verify. The shop class instructor specialized in carburetors. Since the year was 1982 the carburetors where computer-controlled with MC (mixture control) solenoids.
Our instructor told a story about a computer controlled carburetor that had a base plate gasket that contained a fuel heating grid below the throttle plates. The teacher stated that this fuel heating grid heated the atomized fuel as it passed from the throttle plates into the intake manifold.
The Instructor said that this carburetor setup was responsible for 50 plus miles per gallon on a 302 V-8 Ford LTD. He did indicate that (more…)
